"Oliver could see that Byron was stuck deep in the mud. Strong cables were attached between the two machines. Oliver pulled and struggled, but every time he backed up, he kept on tilting."
I understand I’m very late to this video. If this ever happens to anyone you you need to get the truck home or to a shop, you can pull the VGT fuse under the hood. The turbo will go to fully open vane position and stay there. It’ll be a little smokey in lower RPMs but will sound like a 5.9 and drive like a big turbo 5.9 with inadequate fuel. It will be a little doggy in the lower rpm’s but it’s safe to drive that way. You need to pull the fuse before the vanes stick closed though (like this video.) They normally give you some warning before failing completely.
Bring back the old gear driven diesel engines The hell with the emissions crap It’s obvious that the US is the only country in the world 🌍 that has emissions crap 💩 On the engines gas or diesel
Haha mine did this put the fleece cheetah. on my stock turbo the actuator stuck then the stud on the hot side impeller came out seized the turbo up haha had to replace it so went with a fleece
Lol I got a faulty actuator so it’s fine until I step on it then it dumps hella coal for like 3 seconds then you can hear the turbo open up super late and it clears up
I'm an ex combat engineer, used to end op in all sorts of sticky situations. What i would have done, was removed as much dirt/mud behinde the bull's tracks as possible, the hook the bull to the diggers undercarriage, start to drive. And then use your arm in the digger to pull you and the bull out 😎✌️ But nice job, and thanks for the action here on YT 👍
Inexperience will kill your equipment, your project and overall budget... Even the relief operator seems inexperienced as well 😂😂😂.... 2 peices of rail ties should always be able in wet conditions
Huh
Curling the bucket really helps
1489#регнн
Где тебя черты носят !!!
"Oliver could see that Byron was stuck deep in the mud. Strong cables were attached between the two machines. Oliver pulled and struggled, but every time he backed up, he kept on tilting."
Video is terrible
Put some new tracks on that dozer , there flat plates. I don’t think it could pull a sick whore off a piss pot on dry ground!
Может сначала ковшом стоило бы поработать ?
He suppose to remove the mud at the back of bulldozer first before pulling out
I understand I’m very late to this video. If this ever happens to anyone you you need to get the truck home or to a shop, you can pull the VGT fuse under the hood. The turbo will go to fully open vane position and stay there. It’ll be a little smokey in lower RPMs but will sound like a 5.9 and drive like a big turbo 5.9 with inadequate fuel. It will be a little doggy in the lower rpm’s but it’s safe to drive that way. You need to pull the fuse before the vanes stick closed though (like this video.) They normally give you some warning before failing completely.
Bring back the old gear driven diesel engines The hell with the emissions crap It’s obvious that the US is the only country in the world 🌍 that has emissions crap 💩 On the engines gas or diesel
Got dizzy from the camera work!
Haha mine did this put the fleece cheetah. on my stock turbo the actuator stuck then the stud on the hot side impeller came out seized the turbo up haha had to replace it so went with a fleece
Yup that's the actuator
Mother natures way of saying "no"
楽しそう☺
Bunch of ......
Like getting stuck here wasn't totally predictable. I'd send that operator back to school.
My 2001 Cummins is making that clock noise while it’s under boost as well what does it mean?
Knock, your timing is throwb
Lol time for a turbo or rebuild it time...your hot side nozzle is stuck🤭
Lol I got a faulty actuator so it’s fine until I step on it then it dumps hella coal for like 3 seconds then you can hear the turbo open up super late and it clears up
Mine does the same, throttle response seems like it’s really laggy
That's why you don't drive a dozer into a mud pond.
Надо кирпичи падложыть или доску под гусенец следующей рас
3 idiots. Dozer operator, Excavator operator, and the Camera operator.
Экскаватор бок став заде под гусянки копать
Его надо копать глубже
Яма глубже надо
Копать заде бульдозера
Sana o makinayı verende suç
I'm an ex combat engineer, used to end op in all sorts of sticky situations. What i would have done, was removed as much dirt/mud behinde the bull's tracks as possible, the hook the bull to the diggers undercarriage, start to drive. And then use your arm in the digger to pull you and the bull out 😎✌️ But nice job, and thanks for the action here on YT 👍
Inexperience will kill your equipment, your project and overall budget... Even the relief operator seems inexperienced as well 😂😂😂.... 2 peices of rail ties should always be able in wet conditions
Dancukkkk... Kameranya menyakitkan mata cukkkkk... 😇😇😇
I like your video ❤
Bos. Kalo narik posisi sproket ya di belakang
Estica a lança para puxar,é faça uma.barreira de terra na roda guia,para ficar mais alta que a roda motris
Ii
Техника по уши в глине, но на твёрдую почву выбрались) Молодцы.
Parabéns Deus abençoe sempre vcis agradeço pelo vídeo
Big ole expensive tractor stuck in the mud. Johnny cash’s dad (walk the line)
Your video is similar to my video,😘
what a bunch of idiots
Dud, you might try digging from behind him before you pull !!
My 2012 750 is doing that. Turned out to be vgt acuatir not calibrated when they installed the new turbo
Wrong tracks for going through mud like that
Neither one of them are operators the tracko operator needs a dig some of the muck out behind the bulldozer I would fire both
ua-cam.com/video/Pjhs42_A-vY/v-deo.html
Why the hell does the Dozer operator keep spinning the tracks. I want to drag him out of the cab & give him a slap.
Una PC 480 ya lo hubieras sacado
а стабилизацию у камеры включить религия не позволяет?
Seen this done irl and it is fun to watch! 😊